Publicaciones (42) Publicaciones de MIQUEL NOGUES AYMAMI

2019

  1. Atraumatic laparoscopic intraperitoneal mesh fixation using a new laparoscopic device: an animal experimental study

    Hernia, Vol. 23, Núm. 6, pp. 1123-1132

  2. Development of an easily adaptable three-point hitch dynamometer for agricultural tractors. Analysis of the disruptive effects on the measurements

    Soil and Tillage Research, Vol. 194

2018

  1. Efficiency analysis of a multiple axle vehicle with hydrostatic transmission overcoming obstacles

    Vehicle System Dynamics, Vol. 56, Núm. 1, pp. 55-77

  2. Surgical dynamometer to simultaneously measure the tension forces and the distance between wound edges during the closure of a laparotomy

    Sensors (Switzerland), Vol. 18, Núm. 1

2014

  1. Influence of the transmission configuration of a multiple axle vehicle on the obstacle surmounting capacity

    Vehicle System Dynamics, Vol. 52, Núm. 9, pp. 1191-1210

2013

  1. Efficiency sensitivity analysis of a hydrostatic transmission for an off-road multiple axle vehicle

    International Journal of Automotive Technology, Vol. 14, Núm. 1, pp. 151-161

2012

  1. Active bogies and chassis levelling for a vehicle operating in rough terrain

    Journal of Terramechanics, Vol. 49, Núm. 3-4, pp. 161-171

  2. An embedded real-time red peach detection system based on an OV7670 camera, arm Cortex-M4 processor and 3D look-up tables

    Sensors (Switzerland), Vol. 12, Núm. 10, pp. 14129-14143

  3. Analysis of a hydrostatic transmission driveline for its use in off-road multiple axle vehicles

    Journal of Terramechanics, Vol. 49, Núm. 5, pp. 245-254

  4. Definition of linear color models in the RGB vector color space to detect red peaches in orchard images taken under natural illumination

    Sensors (Switzerland), Vol. 12, Núm. 6, pp. 7701-7718

2011

  1. Comparison of different bogie configurations for a vehicle operating in rough terrain

    Journal of Terramechanics, Vol. 48, Núm. 1, pp. 75-84

  2. Measuring oscillating walking paths with a LIDAR

    Sensors, Vol. 11, Núm. 5, pp. 5071-5086

2009

  1. Comparison of stratification in a water tank and a PCM-water tank

    Journal of Solar Energy Engineering, Transactions of the ASME, Vol. 131, Núm. 2, pp. 0245011-0245015

  2. Effect of internal heat recovery in ammonia-water absorption cooling cycles: Exergy and structural analysis

    International Journal of Thermodynamics, Vol. 12, Núm. 1, pp. 17-27

  3. Experimental evaluation of commercial heat exchangers for use as PCM thermal storage systems

    Applied Energy, Vol. 86, Núm. 10, pp. 2047-2055

  4. Utilization of phase change materials in solar domestic hot water systems

    Renewable Energy, Vol. 34, Núm. 6, pp. 1639-1643

2008

  1. Energetic and exergetic analysis of a domestic water tank with phase change material

    International Journal of Energy Research, Vol. 32, Núm. 3, pp. 204-214

2007

  1. Comparison of stratification in a water tank and a PCM-water tank

    Proceedings of the Energy Sustainability Conference 2007

  2. Thermal energy storage with phase change materials in building envelopes

    Contributions to Science, Vol. 3, Núm. 4, pp. 501-510

  3. Use of alternative energy sources in tanneries

    Journal of the Society of Leather Technologists and Chemists, Vol. 91, Núm. 3, pp. 93-101